Ogden & Weber County flashing repair referrals

Flashing & Chimney Leak Repair in Ogden, UT

Tell us where water is entering around a chimney, skylight, or dormer and an independent local roofer serving Weber County will follow up with a free quote.

Why metal flashing—not roof tar—stops chimney and wall leaks in Ogden

Across Ogden's East Bench, the Jefferson Avenue Historic District, South Ogden, and older Riverdale neighborhoods, masonry brick chimneys and multi-plane roof junctions account for a massive share of recurring roof leaks. Years of Weber County snow sitting piled behind a chimney chase, combined with repeated freeze-thaw expansion, pull apart surface caulk and roof cement in a single winter.

Too many quick-fix patches smear thick black roof mastic against brick mortar joints. That tar dries brittle under Ogden's high-elevation UV light, shrinks away from the masonry, traps moisture inside the bricks, and starts leaking again by the very next spring thaw.

Where do flashing failures happen most often on Weber County homes?

  • Brick chimney step and counter-flashing: Proper chimney waterproofing uses two separate metal systems: individual step flashing pieces woven into every shingle course along the chimney sides, covered by counter-flashing whose top edge is saw-cut (reglet-cut) into the brick mortar joints and sealed—not merely glued flat against the face of the brick.
  • Missing chimney crickets (saddles): Wide chimneys sitting perpendicular to a sloped roof trap heavy Wasatch Front snowdrifts and funnel meltwater directly against the uphill face of the masonry. Building a framed metal-clad cricket behind the chimney splits snowmelt cleanly around both sides.
  • Roof-to-wall and dormer step flashing: Split-level homes, two-story additions, and historic Ogden Queen Anne or Craftsman dormers meet vertical siding or brick walls where kick-out flashing is essential. Missing kick-out flashing at the bottom of a wall intersection dumps roof runoff straight behind siding and into interior drywall.
  • Skylight curb flashing kits: Older acrylic-dome or glass skylights develop dried perimeter gaskets and corroded curb aprons, especially when winter snow sits banked against the uphill frame for weeks.
  • Chimney masonry vs. roof flashing leaks: Sometimes the metal flashing is intact, but cracked concrete chimney crowns, spalling bricks, or missing flue caps let snowmelt soak down inside the masonry itself. A careful roof inspection distinguishes flashing failure from masonry work so you hire the right repair scope.

Our part in flashing and chimney repairs

Roofing Repair Ogden is an independent referral service and does not bend sheet metal or perform chimney work ourselves. Share your city and leak symptoms online, and we forward your inquiry to an independent licensed local roofing contractor serving Weber County who inspects the junction in person and gives a free written quote.

Get a Free Estimate

Areas We Cover in Weber County

Flashing systems repaired or rebuilt by local contractors

Every roof intersection moves slightly as temperatures swing across Weber County seasons. Proper sheet-metal flashing sheds water mechanically instead of relying solely on sealant.

Reglet-cut chimney counter-flashing and step flashing

Removing failed roof tar, weaving fresh aluminum or galvanized step flashing with surrounding shingles, grinding mortar reglets into brick chimneys, and tucking overlapping counter-flashing.

Chimney cricket (saddle) framing and metal wrapping

Constructing a pitched diverter behind wide uphill chimney faces so heavy Weber County winter snowmelt drains around the masonry instead of ponding behind it.

Roof-to-wall step and kick-out diverter flashing

Replacing rusted wall flashing along second-story walls, garage tie-ins, and dormers, and installing kick-out flashing at the bottom eave to steer runoff into the gutter.

Skylight reflashing and ice-barrier tie-in

Pulling surrounding shingles around leaking skylights, wrapping the curb in self-adhering ice-and-water membrane, and installing manufacturer-matched metal apron and step kits.

Dead-valley and porch-roof transition flashing

Rebuilding leak-prone transitions where steeper main roofs drain onto lower-pitched porch roofs—a classic detail on 1910s–1930s Ogden brick bungalows.

Published flashing & chimney leak benchmarks (non-binding reference)

Flashing repair scopePublished reference rangeSource
Minor vent-pipe or small apron flashing repair$150 to $400Angi / This Old House
Moderate chimney flashing rebuild, skylight reflashing, or wall step flashing$1,000 to $2,000Angi / HomeAdvisor / This Old House
National average residential roof repair$1,150 to $1,176 (typical $395 to $1,971)Angi / HomeAdvisor
Complex cricket framing, masonry-adjacent deck rebuild, or multi-dormer flashing$3,000 to $8,000+HomeAdvisor / This Old House
Exact flashing quote for your Weber County homeDepends on height, pitch, brick condition, and deck rotOn-site independent contractor bid

Dollar ranges reflect published third-party national surveys (Angi, HomeAdvisor, and This Old House, checked November 2026) and are not quotes or offers. Masonry crown or tuckpointing repairs, if needed separately from sheet-metal roof flashing, are quoted separately by qualified pros.

Why Use a Referral for Flashing & Chimney Leak Repair?

Built for Ogden's older brick and multi-plane homes

Connect with independent local contractors familiar with historic Ogden masonry chimneys, dormers, and deep porch-roof tie-ins.

Mechanical flashing over temporary tar patches

Our guides help homeowners ask the right questions about step flashing, mortar reglets, ice barriers, and kick-out diverters.

Zero referral charge for homeowners

Submitting your project online is free, and you are under zero obligation to accept any quote.

Verify Utah licensing directly

Check the independent contractor's active Utah DOPL S280, R100, or B100 license at secure.utah.gov/llv/ before hiring.

Contact Us Today for a Free Estimate

Dealing with water stains near a chimney, skylight, or dormer in Weber County? Submit your details online for a free independent estimate.

Get a Free Estimate

Free — no obligations

How chimney and flashing leak repairs proceed

1. Identify the roof feature

Tell us via the estimate form whether the leak sits near a brick chimney, metal flue, skylight, dormer, or second-story wall junction.

2. Local contractor match

We route your details to an independent Weber County roofing contractor experienced in residential flashing rebuilds.

3. Junction and attic inspection

The contractor inspects exterior metal, brick mortar joints, and interior attic sheathing to confirm whether flashing, shingles, or masonry is letting water in.

4. Sheet-metal rebuild and shingle weave-in

Upon your approval, the independent contractor installs fresh underlayment, step flashing, and counter-flashing under their written contract.

Roofing Repair Services Available in Ogden, UT

Get a Free Estimate